Chapter 6 General
6.5 Installation Procedure
6-18
6.5.2 Installing the Drum/Toner Cartridge
When handling the drum/toner cartridge, take note of the following points:
WARNING
Never throw a drum/toner cartridge into an open flame. Toner remaining
in the cartridge can cause an explosion and you can get burnt.
• Do not subject it to direct sunlight or strong light.
• When installing the drum/toner cartridge, select a location not subject to strong light and try
to finish the installation within 5 minutes.
• Do not touch the surface of the photosensitive drum. Do not let the drum/toner cartridge
stand or place it upside down. The drum might get damaged.
• A drum shutter protects the photosensitive drum from light. Do not open the drum shutter.
• Although the toner is not harmful to the body, wash it off immediately if your hands or clothes
are stained with it.
• It is recommended to use up the drum/toner cartridge within 1 year after opening it.
1. Open the front cover while pressing the front
cover open/close levers of the printer.
Important
• Do not touch any parts inside the printer.
2. Hold both sides of the top cover by the grip and
open it slowly.
3. Take the drum/toner cartridge out of the box and
shake it 7 to 8 times as shown in the diagram.
To Next Page
Loading...
Need help?
General
