Chapter 6 General
6.1 Specifications
6-14
6.1.12.4 Log Function
6.1.12.5 Maintenance
1) Firmware Update
User can update the ESS Firmware.
Update can be done from a Windows PC with the dedicated utility.
When the Firmware Update fails due to errors in rewriting, the update can be carried out using
other means. (via USB, 1284)
2) Diagnostic Function
There is one type of diagnostic functions as follows.
When power is connected, automatic diagnosis is carried out to check whether hardware
such as ROM and RAM is operating normally.
6.1.12.6 Power Saver
1) Power Saver Modes
The printer has 1 Power Saver mode to reduce power consumption when it is left idle. When no
print data is received for a period of time, the printer will enter the Power Saver mode.
The switch to Low Power mode cannot be prohibited. (Cannot be disabled)
2) Power Saver Mode Timer
The time between Standby mode and Low Power mode can be specified.
3) Resume from Power Saver mode
Printer returns to Normal mode when a print job is received or button on the Control Panel is
pressed in Low Power mode.
Counter Function
Total page Counter This counter is counting the whole printing page except
jammed page.
The maximum count value is one million.
Toner cartridge page Counter This counter is counting the printing page for the Drum/toner
cartridge (EP Cartridge).
Paper Counter This counter is counting the paper for the MSI and the 250
Cassette.
The maximum count value is 32,000.
Applies To
Windows
via USB via 1284
ESS Yes Yes
Mode Power Saver Details Default
Low Power mode Fusing: Paused, Exposure: Paused, Recording:
Paused, Fan: Paused
Enabled
only
Mode Specifying Switch Time Default
Standby mode to Low Power mode Specify between 0-60min in increments of 10min 10min