Hioki 8835-01 - Page 129

107
────────────────────────────────────────────────────
6.2 Making Settings
────────────────────────────────────────────────────
Method Screen: STATUS 1
1. Press the STATUS key to call up the
STATUS 1 screen.
2. Move the flashing cursor to the format item,
as shown in the figure on the left.
3. Use the function keys to select the display
format.
: Single
: Dual
: Quad
4. If dual or quad screen display was chosen in
step 3, determine which input channel to
display on which graph. This setting is
made with the CHANNEL 1 screen.
Press the CHAN key to call up the
CHANNEL 1 screen.
Use the CH SELECT key to open selected
channel screen.
Move the flashing cursor to the point shown
in the illustration at left.
・The illustration shows the setting for CH1.
・Settings for CH2 - CH8 should be made in
the same way.
Use the function keys to select the graph.
: Display the waveform on graph 1.
: Display the waveform on graph 2.
: Display the waveform on graph 3. (*)
: Display the waveform on graph 4. (*)
*: when the quad screen display is selected