186
────────────────────────────────────────────────────
8.6 Using the Analog Trigger Function
────────────────────────────────────────────────────
1.000 V
Trigger leve
3. Set the trigger level.
The rms value as well as the trigger level are
displayed
(1) Move the flashing cursor to the position
shown in the figure on the left.
(2) Use the
JOG control or the function keys
to set the trigger level.
(On the DISPLAY screen, the setting
cannot be made with the
JOG control.)
: Value up, large step
: Value up, small step
: Value down, small step
: Value down, large step
Example
For a signal such as shown in the illustration (frequency 50 Hz), the following
applies:
Vmax. < 1.000 V (RMS < 707.1 mVrms)
To perform trigger measurement under the above conditions, make the
following setting.
Voltage drop f = 50 Hz Level = 1.000 V (707.1 mVrms)
To Next Page
Loading...
