Hioki 8835-01 - Page 238

216
────────────────────────────────────────────────────
9.4 Scaling Function [ SCALING ]
────────────────────────────────────────────────────
NOTE
1
. Scaling ON/OFF
2. Set voltage value conversion valu
e
3. Enter engineering unit (EU
)
Method 1 Screen: SYSTEM 2 (SCALING)
1. Move the flashing cursor to the channel for
which you want to perform scaling and use
the function keys to make the setting.
: Scaling not used
: Scaling used (specify exponent as integer)
: Scaling used (specify exponent as multiple
of 3)
If the exponents of data are integers (SCI), the numeral used as the cursor
value or the value to be printed out will be expressed as it is rather than in
exponential form, provided that it is 0.0001 to less than 100,000.
2. Enter the two points.
・Enter the voltage value on the left and the
corresponding converted value on the right.
・The setting range is -9.9999E+9 to
+9.9999E+9.
Move the flashing cursor to each digit and
use the JOG control or the function keys to
enter individual digits.
(Use the cursor keys to move the column.)
: Value up
: Value down
: Reset
: Enter the value using the numeric keys.
3. Enter the "Unit name: EU".
Move the flashing cursor to the position
shown in the figure on the left and enter the
required unit. See Sections 9.4.3.