Hioki 8835-01 - Page 269

247
────────────────────────────────────────────────────
10.2 Selecting Waveform or Numeric Print
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
NOTE
Numeric print
Method Screen: STATUS 1 in each function
1. Press the STATUS key to call up the
STATUS 1 screen.
2. Move the flashing cursor to the print mode
item, as shown in the figure on the left.
3. Use the function keys to select numeric data.
: Perform waveform print
: Perform numeric print
4. Move the flashing cursor to the print interval
item.
5. Use the JOG control or the function keys to
select the print interval.
: Move the cursor up in the selection window.
: Move the cursor down in the selection
window.
・When the print interval longer than the recording length is set, only the
first do is printed.
・In the recorder and RMS recorder functions (except 5 s/DIV), the maximum
and minimum values are printed (see Section Appendix 3.4).
・In the recorder and RMS recorder functions, the print interval is 1 to 100
DIV before a waveform is captured. The print intervals of 0.01 to 0.5 DIV
can be selected after a waveform is captured.