Hioki 8835-01 - Page 367

345
────────────────────────────────────────────────────
16.2 Removing the Battery Before Discarding the 8835-01
────────────────────────────────────────────────────
16
17
18
19
5
6
7
8
9
10
11
12
13
14
A
WARNIN
G
To avoid the risk of electric shock, be sure that all cables and the power
cord are disconnected before removing the battery.
Dispose of the battery as prescribed in your community.
Lithium battery
1
6.2 Removing the Battery Before Discarding
the 8835-01
・The 8835-01 incorporates a lithium battery for memory backup.
・Before final disposal of the 8835-01, remove the battery as described below.
Removing the battery
1. Verify that the power is switched OFF.
2. Disconnect all input cables and the power cord.
3. Remove the 8 screws which fasten the rear panel, using a Phillips screwdriver.
4. Remove the rear panel. The battery is located in the position on the PCB
shown in the figure.