Hioki 8835-01 - Page 62

40
────────────────────────────────────────────────────
3.1 Basic Operation
────────────────────────────────────────────────────
〔When the recording length is 100 divisions〕
TAB
Displyed part (10 divisions
)
Displyed par
t
Displyed par
t
Trigger position A cursor B curso
r
･Time axis magnification ratio: ×
1
･Time axis magnification ratio: ×
2
･Time axis magnification ratio: × 1/
2
Whole recording lengt
h
Currently displaye
d
screen
Destination
The record is divided into four equal sections
.
U
pper limit value of the displayed channe
l
L
ower limit value of the displayed channe
l
Trigger position
A cursor positio
n
B cursor positio
n
NOTE
Shifting the display position
The new waveform display position can be
specified, and the waveform can be shifted.
: Displays the level monitor (see Section 7.11).
: Shifts the destination to the left.
: Shifts the destination to the right.
: Executes the dislocation.
・Dislocation can be specified for the following eight sections of the record.
1. Front sections of four equally divided sections of the record
2. End section of record
3. A and B cursor positions
4. Trigger position
・If the recording length is equal to or less than four times the width of the
waveform display screen, the dislocation function is not enabled.
・You can escape from the position display or level monitor display by
pressing the
VIEW key. Since the last mode is stored in memory, the mode
can be recalled by pressing the
VIEW key again. (When you have escaped
from the level monitor display by pressing the
VIEW key, when the key is
pressed again, the level monitor display reappears.)