44
────────────────────────────────────────────────────
3.2 Basic Measurement and Setting Procedures
────────────────────────────────────────────────────
(5) Settings on the CHANNEL 1 screen
Make the following settings with the CURSOR keys and function keys.
range: 500 mV/DIV
zoom: 1
zero position: 50%
low-pass filter: OFF
(6) Measurement
・Press the START key, and the LED above the START key lights. In this
case the input is already present, so the trigger will take effect immediately.
・When the waveform has been captured for the specified recording length,
the LED goes off, the unit enters the stop state, and the auto print function
set in step (3) operates, and the waveform is printed. (The waveform below
is printed, with the gauge function enabled on the SET UP (SYSTEM 1)
screen.)
To Next Page
Loading...
