Wireless configuration
Wireless coverage
4-6
Using only three frequencies across multiple cells in North America.
This strategy can be expanded to cover an even larger area using three channels, as shown in
the following figure.
Using three frequencies to cover a large area in North America. Gray areas indicate
overlap between two cells that use the same frequency.
Distance between APs
Not supported on: E-MSM430, E-MSM460, E-MSM466
In environments where the number of wireless frequencies is limited, it can be beneficial to
adjust the receiver sensitivity of the AP. To make the adjustment, select Controlled APS >>
Configuration > Radio list > [radio] and set the Distance between access points
option.
For most installations, Distance between access points should be set to Large. However,
if you are installing several wireless APs and the channels available to you do not provide
enough separation, reducing receiver sensitivity can help you to reduce the amount of
crosstalk between wireless APs.
To Next Page
Loading...
Need help?
General
