Working with VSCs
VSC configuration options
5-29
Location-aware
This option enables you to control logins to the public access network based on the AP, or
group of APs, to which a user is connected. It is automatically enabled when a VSC is set to
Access control.
Location-aware is always enabled when using the controller for authentication or access-
control with a remote RADIUS server.
For each user login, location-aware sends the PHY Type, SSID, and VLAN to the remote
RADIUS server. It also includes the specified Called-Station-Id content.
Wireless MAC filter
This option enables you to control access to the wireless network based on the MAC address
of a device. You can either block access or allow access, depending on your requirements. To
configure this option, see Configuring MAC-based filters on a VSC on page 10-19. Up to 64
MAC addresses can be defined per VSC.
To Next Page
Loading...
