Mobility traffic manager
Configuring Mobility Traffic Manager
9-10
Connect to the management tool on all other controllers, that will be part of the mobility
domain and do the following:
1. Select Controller >> Management > Device discovery.
2. Select Mobility controller discovery.
3. Specify the IP address of the primary mobility controller. This can be the address of
its Internet port or LAN port as long as the port is reachable. For example, if the primary
is at 192.168.5.1, you would configure the other controllers as follows:
4. Select Save.
Defining network profiles
Global definitions for all home networks and local networks are created using the network
profiles feature which is found on the Controller >> Network > Network profiles page.
Initially, two profiles are defined as shown.
To create a new profile, select Add New Profile.
For each network profile you can define a VLAN ID or just a name.
To Next Page
Loading...
Need help?
General
