Working with RADIUS attributes
Colubris AV-Pair - Site attribute values
15-53
Where:
When a user session is terminated based on a quota, a new non-standard termination cause is
used. The value for this termination cause is 0x8744. You can customize this by modifying the
value of “radius-quota-exceeded-cause” in the “ACCESS-CONTROLLER” section of the
configuration file.
Default user data rates
These keywords let you define data rate limits for all users that do not have a specific limit
set in their profile.
Syntax
default-user-max-input-rate=value
default-user-max-output-rate=value
Where:
Default user one-to-one NAT
This keyword lets you define the default setting for one-to-one NAT support for all users that
do not have this setting specified in their profile. This feature only applies to users making
IPSec or PPTP VPN connections with a remote site via controller Internet port. For more
information, see VPN one-to-one NAT on page 3-9 and One-to-one NAT on page 15-69.
Syntax
default-user-one-to-one-nat=value
Where:
Parameter Description
value
For packets: 32-bit unsigned integer value.
For octets: 64-bit unsigned integer value.
Parameter Description
value
For packets: 32-bit unsigned integer value.
For octets: 64-bit unsigned integer value.
Parameter Description
value
Set this to 1 to activate one-to-one NAT support.
To Next Page
Loading...
Need help?
General
