Working with VSCs
Creating a new VSC
5-44
Creating a new VSC
To add a VSC, select Controller > VSCs >>VSC Profiles > Add New VSC Profile.
Define VSC parameters and select Save. Familiarize yourself with sections of interest in VSC
configuration options on page 5-5. See the online help for parameter descriptions.
Assigning a VSC to a group
When working with controlled APs, VSC definitions must be bound to a group so that they
will automatically be activated on the APs in the group. For information on how to bind
(assign) a VSC to a group, see Binding a VSC to a group on page 6-26.
On the MSM317, VSCs can also be bound to a switch port. See the MSM317 Access Device
Installation and Getting Started Guide.
Note When working with autonomous APs, the VSC definition you create on the controller must be
manually configured on each autonomous AP. See Working with autonomous APs on
page 19-1 and the MSM3xx/MSM4xx Management and Configuration Guide.
To Next Page
Loading...
