Working with RADIUS attributes
Colubris AV-Pair - User attribute values
15-69
Data rate
This keyword sets the transmit and receive rates for a user’s session. These rates are applied
on a per-user basis providing direct control of a user’s throughput in Kbps. Two keywords are
available:
max-input-rate: Controls the data rate at which traffic can be transferred from the user to
the controller.
max-output-rate: Controls the data rate at which traffic can be transferred from the
controller to the user.
Note The settings for bandwidth level always take precedence over user data rates. This means if
you set a data rate which exceeds the configured bandwidth level, the rate is capped at the
bandwidth level.
Syntax
max-output-rate=rate
max-input-rate=rate
Where:
One-to-one NAT
Note This feature only applies to client traffic using IPSec or PPTP on the Internet port.
Add this keyword if the user requires a unique IP address when NAT is enabled on the
controller. For more information, see VPN one-to-one NAT on page 3-9 and Default user one-
to-one NAT on page 15-53.
Syntax
one-to-one-nat=value
Where:
Parameter Description
rate
Maximum transmit or receive speed in Kbps.
Parameter Description
value
Set this to 1 to activate one-to-one NAT support.
To Next Page
Loading...
Need help?
General
