Network configuration
Address allocation
3-13
2. Select Add New Profile.
3. Configure profile settings as follows:
Under Settings, specify a Name for the profile.
To assign a VLAN, select VLAN and then specify an ID.
If the profile will be used on an Ethernet port, you can also define a range of VLANs.
This enables a single VLAN definition to span a large number of contiguously
assigned VLANs. Specify the range in the form X-Y, where X and Y can be 1 to 4094.
For example: 50-60.
An IP address cannot be assigned to a VLAN range.
You can define more than one VLAN range by using multiple profiles. Each range
must be distinct and contiguous.
4. Select Save.
Address allocation
The controller can operate as a DHCP server or DHCP relay agent on the LAN port. This
enables it to assign IP addresses to downstream devices connected to the LAN port.
By default, address allocation is disabled. To configure address allocation settings, select
Controller >> Network > Address allocation.
For information on VPN address pool, see Configure an IPSec profile for wireless client VPN
on page 16-4.
To Next Page
Loading...
Need help?
General
