Mobility traffic manager
Configuring Mobility Traffic Manager
9-13
6. Select Save.
Assigning local networks to an AP
Each AP can be configured to support one (or more) local networks. By comparing the home
network assigned to a user with the list of local networks associated with an AP, MTM can
determine if the user is at home or roaming.
Local networks can be assigned by selecting one of the following (depending on whether you
want to define local networks for all APs, a group of APs, or a single AP):
Controller > Controlled APs >> Configuration > Local networks
Controller > Controlled APs > [group] >> Configuration > Local networks
Controller > Controlled APs > [AP] >> Configuration > Local networks
In all cases you will see the Home networks configuration page.
Local networks
Select the local networks that are connected to the Ethernet port(s) on the AP.
Available networks: This box lists all network profiles defined on the controller. Select
a network profile and then select the right arrow to assign it as a local network on the AP.
Local networks: This box lists all the networks that are local to the AP. These networks
are used to determine if a user is roaming or at home when they connect to the AP.
To Next Page
Loading...
Need help?
General
