Working with VPNs
Securing wireless client sessions with VPNs
16-5
Configure L2TP server for wireless client VPN
1. On the page Controller >> VPN > L2TP server enable L2TP over IPSec
configuration- LAN port.
2. Either select X.509 certificates and install an X.509 security certificate (see IPSec
certificates on page 12-11), or specify a Preshared key.
Note The VPN client running on the wireless device must also be configured with a matching
X.509 certificate, or the Preshared key specified here.
3. Set Address source to VPN address pool.
See the online help for option descriptions.
Configure PPTP server for wireless client VPN
1. On the page Controller >> VPN > PPTP server enable PPTP server configuration -
LAN port.
2. Set Address source to VPN address pool. See the online help for option descriptions.
VPN address pool
When securing wireless client sessions with VPNs, it is typically necessary to provide an IP
address to each client. To define a pool of addresses for this purpose, follow this procedure.
1. Select Network > Address allocation.
To Next Page
Loading...
Need help?
General
