Working with controlled APs
Configuring APs
6-26
Binding a VSC to a group
To bind a VSC to a group, do the following:
1. Select the target group under Controlled APs.
2. In the right pane, select VSC bindings, then select Add New Binding.
3. Select the VSC profile to which the group will be bound.
4. If you want to assign an egress mapping to the binding, select Egress network and
select the required Network profile. The Egress network can be used to assign all traffic
on the group to a specific VLAN. Other uses are also possible depending on the type of
VSC to which the group is being bound. For more information, see Traffic flow for
wireless users on page 7-6.
5. Select Save.
Working with APs
Manually adding a new AP
You can manually add APs to the controller before connecting the APs to the network. This is
useful, for example, when you want to pre-designate the group into which an AP will be
placed.
1. Select Controlled APs >> Overview > Configured APs.
2. Select Add.
To Next Page
Loading...
Need help?
General
