Working with RADIUS attributes
Colubris AV-Pair - User attribute values
15-71
Redirect URL
The redirect-url keyword is used to specify the target URL for redirection when using an
access list with the REDIRECT action. Only one redirect-url value can be specified in a user
RADIUS account. See Redirect URL on page 15-59.
SMTP redirection
The controller is able to provide SMTP email service on a per-user basis. This enables users
to send e-mail while on the road without the restrictions imposed by most ISPs regarding the
source address of outgoing mail. It works by intercepting the call to a user’s e-mail server and
redirecting it to an SMTP server that you configure. This setting overrides the setting of
Default user SMTP server on page 15-54.
Note For mail redirection to work, the user's email server name must be publicly known. If the e-
mail server name cannot be resolved, mail redirection fails.
Note If an access list definition is active in the controller profile that enables unauthenticated
users to access their SMTP servers, the SMTP redirect feature will not work for these users.
Syntax
smtp-redirect=address[:port][,username,password]
Where:
Parameter Description
address
Specify the IP address or domain name of the e-mail server which is used to
send outgoing redirected mail.
port
Specify the port on the e-mail server to relay to. Range: 1 to 65535. Default:
25
username
Specify the username required to log on to the SMTP server. Maximum 32
characters.
Only supported if the Support authentication on SMTP proxy server
option is enabled on the Public access > Access control page. Works
with SMTP servers that support PLAIN, CRAM-MD5, and no authentication.
password
Specify the password required to log on to the SMTP server. Maximum 32
characters.
Only supported if the Support authentication on SMTP proxy server
option is enabled on the Public access > Access control page. Works
with SMTP servers that support PLAIN, CRAM-MD5, and no authentication.
To Next Page
Loading...
Need help?
General
