Mobility traffic manager
Configuring Mobility Traffic Manager
9-12
Defining local networks on a controller
Local networks on a controller are composed of the following interfaces:
The network connected to the LAN port. Identified by the network profile LAN port
network.
The network connected to the Internet port. Identified by the network profile Internet
port network.
Any VLAN definition created on the Controller >> Network > Ports page.
To add additional VLANs on a controller, do the following:
1. Select Controller > Network > Ports.
2. Select Add New VLAN.
3. Under General, set Port to LAN port or Internet port.
4. Under VLAN, set VLAN ID to the appropriate network profile.
5. Under Assign IP address via, select an addressing method.