Network configuration
Port configuration
3-6
Note If you enable this feature you should not assign static NAT mappings in the range 5000 to
10000.
Size of port range
Sets the number of TCP and UDP ports reserved for each user.
PPPoE client
To configure the PPPoE client on the Internet port, select Controller >> Network > Ports
and then select PPPoE and then Configure.
Settings
Username
Specify the username assigned to you by your ISP. The controller will use this username to
log on to your ISP when establishing a PPPoE connection.
Password/Confirm password
Specify the password assigned to you by your ISP. The controller will use this password to log
on to your ISP when establishing a PPPoE connection.
Maximum Receive Unit (MRU)
Maximum size (in bytes) of a PPPoE packet when receiving. Changes to this parameter only
should be made according to the recommendations of your ISP. Incorrectly setting this
parameter can reduce the throughput of your Internet connection.
Maximum Transmit Unit (MTU)
Maximum size (in bytes) of a PPPoE packet when transmitting. Changes to this parameter
should only be made according to the recommendations of your ISP. Incorrectly setting this
parameter can reduce the throughput of your Internet connection.
Auto-reconnect
The controller will automatically attempt to reconnect if the connection is lost.
To Next Page
Loading...
Need help?
General
