Network configuration
Address allocation
3-14
DHCP server
The DHCP server can be used to automatically assign IP addresses to devices that are
connected to the controller via the LAN port or client data tunnel.
Note Do not enable the DHCP server if the LAN port is connected to a network that already has
an operational DHCP server.
When the DHCP server is active, users can still connect using static IP addresses assigned
on different subnets. To configure this feature, select Public access > Access control
and under Client options, select Allow any IP address.
The DHCP settings on this page are always used by the default VSC. For additional
flexibility, separate DHCP servers can enabled on other access-controlled VSCs to assign
addresses to users. See DHCP server on page 5-30.
The DHCP server feature is not supported when controller teaming is active.
To configure the internal DHCP server, select Controller >> Network > Address
allocation, select DHCP server, and then Configure.
To Next Page
Loading...
Need help?
General
