Mobility traffic manager
Configuring Mobility Traffic Manager
9-15
5. Configure the Wireless security filters so that they do not interfere with roaming
functionality. In most cases, these filters should be disabled. If you need to use them,
note that:
The Restrict wireless traffic to: Custom option can be used provided that it
restricts traffic to destinations that are reachable from all subnets in the mobility
domain.
Neither the Restrict wireless traffic to: Access point’s default gateway nor
Restrict wireless traffic to: MAC address options can be used.
Binding a VSC to an AP
After you have defined a VSC, you need to bind it to all the APs in the mobility domain.
1. Select Controller > Controlled APs > [group] >> VSC bindings and then the VSC
configured for mobility. The VSC binding page opens.
For VSC profile, select the VSC that you just configured for mobility.
You have the option of assigning an Egress network to the binding. When mobility is active
on the VSC, the Egress network is assigned as the user’s home network (unless a dynamic
VLAN is assigned to the user). You also have the option of selecting any untagged interfaces,
such as the default profiles for the LAN port and Internet port.
A number of configuration settings on the controller can affect how user traffic is routed.
Some of these settings may override the choices you make to assign user traffic to a home
network. See Traffic flow for wireless users on page 7-6.
To Next Page
Loading...
Need help?
General
