LLDP
Configuring LLDP on an AP
17-10
ELIN location
Emergency Call Services ELIN as described, for example, by NENA TID 07-501.
Fast Start timer
After an MED LLDPDU is received, this timer is started and the agent sends one MED
LLDPDU to the MED device each second.
LLDP settings
Transmit interval
Sets the interval (in seconds) at which local LLDP information is updated and TLVs are sent
to neighboring network devices.
Multiplier
The value of Multiplier is multiplied by the Transmit interval to define Time to live.
Time to live
Indicates the length of time that neighbors will consider LLDP information sent by this agent
to be valid. Time to live is calculated by multiplying Transmit interval by Multiplier.
Network Policy The network policy TLV is a fixed length TLV that indicates a
port VLAN type, VLAN identifier (VID), and both the Layer 2
and Layer 3 priorities associated with a specific set of
application types.
Location Identification Indicates the physical location of the device using the
following form:
Emergency Call Services ELIN, as described for example
by NENA TID 07-501.
Extended Power-via-MDI Indicates the IEEE 802.1af (PoE) power related information
on the device which includes:
Power type
Power source
Power priority
Power value
MAC/PHY Configuration/
Status
Indicates the following:
Bit-rate and duplex capability
Current duplex and bit-rating
Whether these settings were the result of auto-
negotiation during link initiation or manual override
TLV name Description
To Next Page
Loading...
Need help?
General
