Security
MAC lockout
12-13
MAC lockout
This feature lets you to block traffic from client stations based on their MAC address. MAC
lockout applies to client stations connected to:
Wireless ports on controlled APs
Wired ports (including switch ports) on controlled APs
Local mesh ports on controlled APs
The LAN port on the controller
Note MAC lockout does not apply to the Internet port on the controller.
Adding a MAC lockout address
1. Select Controller >> Security > MAC lockout.
2. Select Add New MAC Address.
3. Specify the MAC address as six pairs of hexadecimal digits separated by colons. For
example: 00:00:00:0a:0f:01.
4. Select Save.
To Next Page
Loading...
Need help?
General
