sFlow
Configuring and activating sFlow
18-3
Note The controller does not generate any sFlow information of its own. The sFlow
information is only generated by APs.
The MSM317 only monitors ingress traffic on the Uplink and switch ports.
MIB support
The following MIBs are supported:
sFlow-MIB base OID: 1.3.6.1.4.1.14706
SNMP MIB2 System base OID: 1.3.6.1.2.1.1
SNMP MIB2 Interfaces base OID: 1.3.6.1.2.1.2 Note: The ifType OID of the SNMP MIB2
Interfaces will have the value 71 (ieee802.11) for the wireless interfaces.
SNMP MIB2 IPAddrTable base OID: 1.3.6.1.2.1.4.20
SNMP MIB2 ifXTable base OID: 1.3.6.1.2.1.31.1.1.1
SNMP MIB: HP-WLAN-SFLOW-EXTENSIONS-MIB base OID: 1.3.6.1.4.1.11.2.14.11.6.4.2
Configuring and activating sFlow
All sFlow configuration occurs via the controller management tool by selecting Controller
>> Tools > sFlow.
To Next Page
Loading...
Need help?
General
