Controller teaming
Team configuration
8-18
Accessing the team manager
To reach the management tool on the team manager, you should always point your browser
to the team IP address, and not the physical address assigned to the manager. In case of
failover, the team IP address will be assigned to the interim manager. This way, you will
always be able to configure the team.
Team configuration options
This section describes the configuration options available on the team manager.
When you select Team in the Network Tree, the menu in the right pane presents all
configuration options that are common to all team members. Any settings that you make
using this menu are synchronized on all team members.
The available options on this menu are identical to what you would see on a non-teamed
controller, except for a few options that are not supported in teaming mode, or if supported,
must be defined individually on each controller. On the team manager, these settings can be
defined by selecting the manager under Controller. Settings for team members must be
defined by directly accessing their management tools.
The following table lists the configuration options that are affected when teaming is active.
Configuration option Notes
Network > Ports page The Port configuration option is not available at
the team level. VLAN and GRE configuration
options are available.
Network > Address allocation The DHCP server option is not supported when
teaming is enabled.
The VPN address pool option is not supported
when teaming is enabled.
Security > Certificate stores
Security > Certificate usage
Not available at the team level.
Not available at the team level.
VPN > IPSec
VPN > L2TP server
VPN > PPTP server
VPN > PPTP client
Not available at the team level.
Not supported when teaming is enabled.
Not supported when teaming is enabled.
Not supported when teaming is enabled.
Authentication > Active Directory The General and Join options are not available at
the team level.
To Next Page
Loading...
Need help?
General
