Working with VSCs
VSC configuration options
5-9
Access control
The settings only apply to access-controlled VSCs.
Present session and welcome page to 802.1X users
Enable this option to have the public access interface present the Welcome, Transport, and
Session pages to 802.1X users.
When disabled, these pages are not sent to 802.1X users.
Note Display of the Session page (and other pages that are part of the public access interface) may
not work for all users. These pages will fail if the initial traffic from the user’s computer is
sent by an application other than the user’s browser. For example: messaging software,
automatic software update services, email applications.
Identify stations based on IP address only
This option only applies when the HTML-based user logins option is enabled.
This option controls how client stations are identified once they are logged in.
When enabled, the controller identifies client stations by their IP address only. This
setting provides support for network configurations where the MAC address of wireless
stations is not visible to the controller, or for configurations where the MAC address
changes when a client station roams.
When disabled (default setting), the controller identifies client stations by both IP
address and MAC address. Both addresses must remain the same after login for the client
station to remain authenticated.
Local NAS ID
Defines a NAS ID for this profile. This ID is used only when RADIUS authentication is not
configured for the profile.
To Next Page
Loading...
Need help?
General
