Working with controlled APs
Configuring APs
6-25
2. Manually define each AP in the appropriate group.
3. Deploy the APs in their default configuration on the network.
4. Allow the discovery process to find the APs and place them in the pre-configured
groups.
Working with groups
Adding a new group
To create a new group, do the following:
1. Select Controlled APs >> Group management.
2. Select Add New Group.
3. Specify the name of the new group and select Save.
Deleting a group
Note You must remove all APs from a group before you delete it.
To delete a group, do the following:
1. Select Controlled APs >> Group management.
2. Select the name of the group you want to delete.
3. Select Delete.
To Next Page
Loading...
