To Next Page

To Previous Page

Management

Management tool

2-8

 The settings under Account inactivity logout must be configured as follows:

 Timeout must be set to 15 minutes or less.

For more information on these guidelines, refer to the Payment Card Industry Data

Security Standard v1.2 document.

Management tool security features

The management tool is protected by the following security features:

 Allowed addresses: You can configure a list of subnets from which access to the

management tool is permitted.

 Active interfaces: You can enable or disable access to the management tool for each of

the following:

 LAN port

 Internet port

 VPN

 VLAN/GRE.

These settings also apply when SSH is used to access the command line interface.

Note Changing the security settings may cause you to lose your connection to the management

tool.

Web server

You can also configure the Web server ports from which access to the management tool is

permitted.

 Secure web server port: Specify a port number for the controller to use to provide

secure HTTPS access to the management tool. Default is 443. Before reaching the

management tool login page, you must accept a security certificate. The default

certificate provided with the controller will trigger a warning message on most browsers

because it is self-signed. To remove this warning message, you must replace the default

certificate. See About certificate warnings on page 12-10.

Note Changing the secure web server port will cause you to lose your connection to the

management tool. To reconnect, you will need to specify the following address:

https://Controller_IP_address:web_server_Port_number.

 Web server port: Specify a port number for the controller to use to provide standard

HTTP access to the management tool. These connections are met with a warning, and the

browser is redirected to the secure Web server port. Default is 80.

HP MSM7XX User Manual

Other manuals for HP MSM7XX