Controller teaming
Controller discovery
8-13
Network Tree
The network tree provides access to configuration options for the team. And shows a status
light for each controller.
Team: team name
Select Team: [name] to access configuration items that apply to all members of the team
and their controlled APs. Configure these options using the main menu in the right pane.
VSC
Select the VSCs node to manage the virtual service communities that are defined on the
team. Once you define a VSC it is automatically synchronized on all member controllers, and
can be assigned (bound) to one or more controlled APs.
Status lights
A status is light is displayed for each VSC.
Green: Indicates that the VSC is properly configured.
Red: Indicates that the VSC has a configuration problem.
Once you define a VSC it is automatically active on the controller.
Controllers
This section lists all controllers that are members of the team. Team members are controllers
that fall into one of the following categories:
The controller was discovered on the network, authorized by an administrator, and
successfully joined the team at least once.
or
The controller was manually added to the team by selecting Add New Controller on the
Overview > Configured controllers page.
Each controller is identified by a name (which is initially set to the controller’s serial number
for discovered controllers). Select a controller’s name to access configuration items that are
specific to the controller. These configuration items are presented in the main menu in the
right pane.
To Next Page
Loading...
Need help?
General
