HP MSM7XX User Manual

Management
Management tool
2-5
Manager and Operator accounts
Two types of administrative accounts are defined: manager and operator.
 The manager account provides full management tool rights.
 The operator account provides read-only rights plus the ability to disconnect wireless
clients and perform troubleshooting.
Only one administrator (manager or operator) can be logged in at any given time. Options are
provided to control what happens when an administrator attempts to log in while another
administrator (or the same administrator in a different session) in already logged in. In every
case, the manager’s rights supersede those of an operator.
The following options can be used to prevent the management tool from being locked by an
idle manager or operator:
 Terminates the current manager session: When enabled, an active manager or
operator session will be terminated by the login of another manager. This prevents the
management tool from being locked by an idle session until the Account inactivity
logout timeout expires.
 Is blocked until the current manager logs out: When enabled, access to the
management tool is blocked until an existing manager logs out or is automatically logged
out due to an idle session.
An operator session is always terminated if a manager logs in. An active operator session
cannot block a manager from logging in.
 Terminates the current operator session: When enabled, an active operator’s session
will be terminated by the login of another operator. This prevents the management tool
from being locked by an idle session until the Account inactivity logout timeout
expires.
Operator access to the management tool is blocked if a manager is logged in. An active
manager session cannot be terminated by the login of an operator.
An operator session is always terminated if a manager logs in. An active operator session
cannot block a manager from logging in.
 Login control: If login to the management tool fails five times in a row (bad username
and/or password), login privileges are blocked for five minutes. Once five minutes
expires, login privileges are once again enabled. However, if the next login attempt fails,
privileges are again suspended for five minutes. This cycle continues until a valid login
occurs. You can configure the number of failures and the timeout.
 Account inactivity logout: By default, if a connection to the management tool remains
idle for more than ten minutes, the controller automatically terminates the session. You
can configure the timeout.

HP MSM7XX Specifications

General

Brand	HP
Model	MSM7XX
Category	Controller
Language	English