Working with RADIUS attributes
User attributes
15-19
IDM can be used to define settings in a user’s RADIUS account that the controller will
retrieve when the user is authenticated, and then apply to the user’s wireless session. The
following PCM settings are supported.
Important
When using PCM to configure settings in a user’s RADIUS account, you should not use
Colubris AV-Pair values to define other settings in the same account. Standard RADIUS
attributes can be used however.
PCM setting Description Supported on VSCs that are ...
Tagged VLAN
(The Untagged VLAN setting
is not supported.)
Specifies a VLAN number only. Names
are not supported.
Access controlled and
Non-access-controlled
QoS Sets the bandwidth level for the user’s
account. PCM numerical values are
mapped to the user account as follows:
6, 7 = VERY-HIGH
4, 5 = HIGH
0, 3 = NORMAL
1, 2 = LOW
Access controlled and
Non-access-controlled
Requires that the Bandwidth control
feature is enabled on the controller
(Controller >> Network >
Bandwidth control) when access-
controlled VSCs are used.
Ingress/Egress rate limit Sets the user’s ingress and egress data
rates in bytes.
Access controlled
Network resources access
rule
Sets a custom access control list for the
user.
Access controlled
To Next Page
Loading...
Need help?
General
