Management
SNMP
2-14
Attributes
System name
Specify a name to identify the controller. By default, this is set to the serial number of the
controller.
Location
Specify a descriptive name for the location where the controller is installed.
Contact
Contact information for the controller.
Port
Specify the UDP port and protocol the controller uses to respond to SNMP requests. Default
port is 161.
SNMP protocol
Select the SNMP versions that the controller will support. Default is Version 1 and Version
2c.
Notifications
Select the SNMP versions that the AP will support. Default is Version 1 and Version 2c.
Notifications
When this feature is enabled, the controller sends notifications to the hosts that appear in the
Notifications receivers list.
The controller supports the following MIB II notifications:
coldStart
linkUp
linkDown
authenticationFailure
In addition, the controller supports a number of custom notifications. Select Configure
Notifications. For a descriptions of these notifications, see the online help.
v1/v2 communities
Community name
Specify the password, also known as the read/write name, that controls read/write access to
the SNMP agent. A network management program must supply this name when attempting to
set or get SNMP information from the controller. By default, this is set to private.
Read-only name
This is the password that controls read-only access to the SNMP agent. A network
management program must supply this name when attempting to get SNMP information from
the controller. By default, this is set to public.
To Next Page
Loading...
Need help?
General
