Management
System time
2-20
Set timezone
Select the time zone in which the controller is located. If you change the time zone setting,
the new value does not take effect until you restart the controller.
Automatically adjust clock for daylight savings time changes
Enable this option to automatically update the clock based on the specified daylight savings
time (DST) rule.
Default DST rule: This is the currently active daylight savings time rule.
Customize DST rules: Select this button to define your own DST rule.
Time server protocol
Select the protocol that will be used to communicate with the time server.
Set date and time (manually)
Use this option to manually set the system date and time.
Set date and time (time servers)
Select this option to have the controller periodically contact a network time server to update
its internal clock. By default, the list contains two ntp vendor zone pools that are reserved for
HP devices. By using these pools, you will get better service and keep from overloading the
standard ntp.org server. For more information refer to: pool.ntp.org.
To Next Page
Loading...
Need help?
General
