LLDP
Configuring LLDP on the controller
17-7
System capabilities (Type 7): Indicates the primary function of the device. Set to:
WLAN access point for APs
Router for controllers.
Management IP address (Type 8): The controller always sends a management IP
address TLV containing the IP address of the port. This optional TLV lets you specify a
secondary IP address on which the agent will respond to management requests. If set to
0.0.0.0, no secondary address is sent.
802.3 TLVs
The IEEE 802.3 organizationally specific TLV set is optional for all LLDP implementations.
The controller supports a single optional TLV from the 802.3 definition.
MAC/PHY configuration/status
This TLV provides the following information:
Bit-rate and duplex capability
Current duplex and bit-rating
Whether these settings were the result of auto-negotiation during link initiation or
manual override.
To Next Page
Loading...
