sFlow
Configuring and activating sFlow
18-6
Collector configuration settings
A collector profile defines the settings that will be used to communicate with a collector.
Name
Friendly name used to identify the collector.
IP address
IP address of the collector.
Timeout
The time (in seconds) that the collector maintains ownership of a sampling instance.
Never expire: Select this option to set the timeout to never expire.
Maximum datagram size
The maximum number of data bytes that will be sent to the collector in a single sample
datagram.
Port
The UDP port on which sFlow data will be sent to the collector.
HP PMM compatibility
Enable this option to generate sFlow data in a format that is compatible with the HP PMM
application. When enabled, information not supported by PMM is dropped from the sFlow
data to conserve network bandwidth.
Active sFlow agents
Agents automatically appear in this table once sFlow support is enabled. An agent will appear
for each controlled AP that is synchronized (green) under Controlled APs in the Network
Tre e.
To configure the agent on an AP, select its name in the list. See sFlow agent settings.
To sort the list based on the values in a column, select the column title.
To Next Page
Loading...
Need help?
General
