Reset Restarts the switch immediately, at a specified time, after a specified 93
delay, or at a periodic interval
Interface 97
Port 98
General 98
Configure by Port List Configures connection settings per port 98
Configure by Port Range Configures connection settings for a range of ports 100
Show Information Displays port connection status 101
Statistics Shows Interface, Etherlike, and RMON port statistics 102
Chart Shows Interface, Etherlike, and RMON port statistics 102
History Shows statistical history for specified interfaces 106
Transceiver Shows identifying information and operational parameters for optical
transceivers which support Digital Diagnostic Monitoring (DDM), and
configures thresholds for alarm and warning messages for optical
transceivers which support DDM
Cable Test Performs cable diagnostics for selected port to diagnose any cable
faults (short, open etc.) and report the cable length
110
111
113
Trunk 115
Static 116
Configure Trunk 116
Add Creates a trunk, along with the first port member 116
Show Shows the configured trunk identifiers 116
Add Member Specifies ports to group into static trunks 116
Show Member Shows the port members for the selected trunk 116
Configure General 116
Configure Configures trunk connection settings 116
Show Information Displays trunk connection settings 116
Dynamic 119
Configure Aggregator Configures administration key and timeout for specific LACP
groups
119
Configure Aggregation Port 116
Configure 116
local side
remote side