Chapter 2
|
Using the Web Interface
Navigating the Web Browser Interface
Table 4: Switch Main Menu (Continued)
dynamic entries in the DHCP Snooping table
Adds an ACL based on IP or MAC address filtering
Shows the name and type of configured ACLs
Configures packet filtering based on IP or MAC addresses and other
Shows the rules specified for an ACL
Binds a port to the specified ACL and time range
Binds a port to the specified ACL and time range
Shows statistics for ACL hardware counters
Sets IP addresses of clients allowed management access via the web,
Shows the addresses to be allowed management access
Configures per port security, including status, response for security
breach, and maximum allowed MAC addresses
Enables authentication and EAPOL pass-through
Sets authentication parameters for individual ports
Displays protocol statistics for the selected port
Protects against Denial-of-Service attacks
Enables DHCP snooping globally, MAC-address verification,
information option; and sets the information policy
Enables DHCP snooping on a VLAN
Sets the trust mode for an interface
Displays the DHCP Snooping binding information
Filters IP traffic based on static entries in the IP Source Guard table, or
Enables IP source guard and selects filter type per port
Adds static addresses to the source guard ACL binding table
Shows static addresses in the source guard ACL binding table
Adds static addresses to the source guard MAC address binding table
Shows static addresses in the source guard MAC address binding table
Displays the source-guard binding table for a selected interface
To Next Page
Loading...
