Chapter 2
|
Using the Web Interface
Navigating the Web Browser Interface
Table 4: Switch Main Menu (Continued)
snooping
multicast router
through static or dynamic configuration
through static or dynamic configuration
each group was learned, and the corresponding source list
Add Multicast Group Range
Assigns multicast groups to selected profile
Show Multicast Group Range
Shows multicast groups assigned to a profile
Assigns IGMP filter profiles to port interfaces and sets throttling action
Shows statistics for query-related messages
Shows statistics for protocol messages, number of active groups
Shows statistics for protocol messages, number of active groups
Shows statistics for protocol messages, number of active groups
Enables multicast filtering; configures parameters for IPv6 multicast
Configures Immediate Leave status for a VLAN
Add Static Multicast Router
Assigns ports that are attached to a neighboring multicast router
Show Static Multicast Router
Displays ports statically configured as attached to a neighboring
Show Current Multicast Router
Displays ports attached to a neighboring multicast router, either
Statically assigns multicast addresses to the selected VLAN
Shows multicast addresses statically configured on the selected VLAN
Shows multicast addresses associated with the selected VLAN, either
Enables MLD filtering for the switch
Adds MLD filter profile; and sets access mode
Shows configured MLD filter profiles
Add Multicast Group Range
Assigns multicast groups to selected profile
Show Multicast Group Range
Shows multicast groups assigned to a profile
Configures the interface to drop MLD query packets
Displays known multicast groups, member ports, the means by which
Shows statistics for MLD ingress traffic
Shows statistics for MLD egress traffic
Shows statistics for query-related messages
To Next Page
Loading...
