1188 Matrix ETERNITY NE System Manual
PIN Dialing
You can record and play a voice message instead of beeps to prompt the user to dial PIN while using the PIN
Dialing feature. See “PIN Dialing” for more details.
Recording Voice Messages
You can record Voice Messages on voice modules from a SLT connected to the SARVAM UCS.
When you record voice messages, make sure that the audio files are recorded in .wav file format, have the
attributes listed below:
• Chunk ID : "RIFF"
• ChunkSize : Filesize-8 (check file size using right click property)
• SubChunk1ID : "frnt"
• Channel :1 (mono)
• Samples per seconds per channels : 8000
• Wav Byte Rate : 8000
• Bit Per Sample: 8
Recording Voice Messages from a Phone
To record a Voice Message from a phone,
• Lift the handset.
• Enter SE mode from the SLT.
Record the Voice Message, dial:
• 2502-Voice Module Number
Where,
Voice Module is from 01 to 16.
• If your phone is an Extended IP Phone, press Enter key.
• You will get a beep.
• At the end of the beep, start recording the message, by speaking into your telephone instrument or if using
an external music source (PC or Music System), play the voice message.
• Limit your message as per the module size you wish to assign to the module.
• Go ON-Hook on completion of the message.
To check/verify the Voice Message you recorded, dial:
• 2503-Voice Module
Where,
Voice Module is from 01 to 16.
In this case, dial the number of the Voice Module you just recorded.
If the audibility of the recorded message is not satisfactory, you may repeat this procedure again.
Voice Module 01 is reserved for Music-on-Hold by default. You are advised not to assign this module to
any other Voice Message Application.
To Next Page
