Matrix ETERNITY NE System Manual 321
This port defines the port on which the VoIP Port of SARVAM UCS listens for SIP messages transported
over TCP. This port is also used as the source port for sending SIP messages to the remote peer. The valid
range for this port is 1025-65535. The default SIP TCP Port is 05060.
• Enter the SIP TLS Port address.
This port defines the port on which the VoIP Port of SARVAM UCS listens for SIP messages transported
over TLS. This port is also used as the source port for sending SIP messages to the remote peer. The valid
range for this port is 1025-65535. The default SIP TLS Port is 05061.
• Enter the RTP Listening Port address. This port defines the port on which the VoIP Port of SARVAM UCS
listens for RTP Packets. This port is also used as the source port for sending RTP packets to the remote
peer. The valid range for this port is 1025-65278. The default RTP Listening Port is 08000.
Timers
Configure the following SIP message related timers:
• Click Timers to expand.
• Set the SIP Invite Timer. This is the time in seconds that SARVAM UCS waits for a response from the
called party after ending the INVITE message. This timer starts after sending INVITE message to the
called party and stops on receipt of the provisional response or the final response or when the user
disconnects the call. On expiry of the timer, the call process is terminated by the SARVAM UCS and an
error tone is played to the user. The range of the SIP Invite Timer is 10-180 seconds. Default: 30 seconds.
• Set the SIP Provisional Timer. This is the time in seconds that the SARVAM UCS waits for the final
response after receiving the provisional response from the called party. This timer starts on the receipt of
the provisional response from the called party and stops on receipt of the final response from the called
party or when the user disconnects the call. On expiry of the timer, SARVAM UCS terminates the call
process and plays error tone to the user. The range of SIP provisional Timer is 10-180 seconds. Default:
60 seconds.
• Set the General Request Timer to the desired duration. This is the time in seconds for which SARVAM
UCS waits for response for a transaction request. This timer starts on the initiation of a transaction. This
timer stops on the receipt of a response for the request. On expiry of the timer, SARVAM UCS clears the
transaction. This timer is used for Registration request. The range of the General Request Timer is 10-60
seconds. Default: 20 seconds.
The Timers will be applicable only after System Restart.
To Next Page
Loading...
