40 Matrix ETERNITY NE System Manual
• Plug the other (short straight) end of the phone cord into the jack at the bottom of the handset.
• If you want to use a Headset (not supplied) with your phone, you may plug any standard stereo
headset with 2.5mm single connector into the headset jack with the symbol on the left side panel
of the phone, as illustrated in the figure below.
OR
You may also plug in a stereo headset with an RJ9 connector into the headset port at the bottom of the
phone, marked with the symbol .
• Connect the LAN Port of SPARSH VP248 to the LAN Switch/Hub or a Router, according to your installation
scenario.
To Next Page
Loading...
