46 Matrix ETERNITY NE System Manual
• Select SIP CoS and define the CoS (priority) bits in all SIP packets. Valid range: 0-7. Default: 3
• Select RTP CoS and define the CoS (priority) bits in all RTP packets. Valid range: 0-7. Default: 6.
• Select PC/VLAN CoS to add VLAN header to all packets entering the PC Port and leaving the LAN port of
the phone. Default: Disabled.
• To configure PC VLAN/CoS, select Enable?.
• Select VLAN ID and enter the same ID as you have assigned to the VLAN in which the computers are
connected. Valid range: 0-4094. Default: 1.
• Select CoS and define the Layer 2 CoS (priority) bits. Valid range: 0-7. Default: 0.
PCAP
To capture packets sent and received from and by the phone for monitoring and troubleshooting, you can enable
PCAP on the phone. The phone captures up to 1 MB of packets. For more information and for instructions on how
to use PCAP Trace on the phone, see “Using PCAP Trace for Matrix SPARSH VP248 Extended IP Phone”, under
PCAP Trace.
MAC Cloning
If you require cloning of the MAC Address, configure the following:
• Select Enable?.
•In Enter Clone MAC Address, enter the address you wish to clone.
802.1x Authentication
If you want to restrict unauthorized clients from connecting to your LAN, you need to enable 802.1x Authentication.
Using EAP MD5 protocol the PC connected to the LAN port of the IP Phone is first authenticated and then it gets
connected to LAN.
You need to configure the following 802.1x Authentication parameters:
• Select Enable?.
• Enter the 802.1x Authentication Identity provided by your network administrator.
• Enter the 802.1x Authentication MD5 Password associated with the identity provided by your network
administrator.
When you change the Network Settings, the phone will restart.
Viewing Network Status
• In the Local Menu of the phone, place the cursor on Network Status and press the Enter key.
To Next Page
Loading...
