Matrix ETERNITY NE System Manual 647
• The Call Back Profile opens in a new window.
• Configure the profile parameters in this window.
• Set the Call Back Timer to the desired duration. This is the duration for which the system waits for the
caller to disconnect the call after the system has found a matching number for the caller’s CLI in the list
you configured.
When the caller disconnects within Call Back Timer, the system applies Call Back on the port. If the caller
does not disconnect within the Call Back Timer, the incoming call management logic is applied for the call
on the trunk port.
The range of this timer is from 01 to 99 seconds. By default, it is set to 10 seconds.
• Select the number which the system must Call Back To. You may select:
• Call Back on same number from which missed call is received. If you select this option, you must
configure the numbers eligible for call back in the Program the numbers for which call back is to be
provided list.
To Next Page
