Matrix Telecom ETERNITY NE - Page 845

Matrix ETERNITY NE System Manual 835
• If the Toll Control Level is 0, then Toll control is time zone based, i.e. Day and Night/Break. The
outgoing call is allowed/denied as per the Call Privilege and the corresponding Allowed and Denied
Number List programmed for that time of the day by the System Engineer.
• If the Toll Control Level is 1, 2, 3 the outgoing call is allowed/denied as per the Call Privilege and the
corresponding number list programmed for each level.
• If Dynamic Lock - Automatic has been set by user/Operator, the system waits for the duration of the
Dynamic Lock Timer set for the extension. At the end of each outgoing call made during the period of this
Timer, the system will restart the Timer again. The system will change the Toll Control back to the previous
Level when no outgoing call is made till the expiry of this Timer.
• If Dynamic Lock - Automatic has been set by user/Operator, and an internal call is made during the period
of the Dynamic Lock Timer, the system will check for the 'Dynamic Lock Timer’ feature in the Class of
Service allowed to the extension.
If this feature is enabled, the system will start the decrement of the Dynamic Lock Timer. The system will
change the Toll Control back to the previous level on the expiry of this Timer. However, if the 'Dynamic
Lock Timer' feature is disabled in the Class of Service, the system will reset the Toll Control as described
in the previous step.
• If Dynamic Lock - Manual has been set, the extension user/Operator must set the Toll Control Level back
to the previous Level.
Feature Interactions
• Redial and Auto Redial: The system will check for Toll Control Level when an extension, on which
Dynamic Lock is set, attempts Redial, but the system will not check it for Auto Redial.
• Emergency Number Dialing: All extensions will be able to dial Emergency numbers always, regardless
of the Toll Control set on them.
SARVAM UCS provides for a separate configuration of Emergency Numbers, which remain unaffected by
Dynamic Lock set on the phones. Refer the “Emergency Dialing” topic to know more about this feature.
How to configure
For this feature to work, it must be enabled in the Class of Service of the extensions.
By default, Dynamic Lock enabled on all extension types during the Day and the Night/Break. So, all extensions of
SARVAM UCS can set Dynamic Lock.
The 'Dynamic Lock Timer' is disabled in the Class of Service of all extension types.