Olympus BondMaster 600 - Page 237

DMTA-10045-01EN, Rev. E, August 2016
List of Figures 227
Figure 6-6 The IMPULSE display ..................................................................................... 127
Figure 6-7 The scan over the disbonds ............................................................................ 128
Figure 6-8 Adjusting the disbond signal angle .............................................................. 128
Figure 6-9 Adjusting the H GAIN and V GAIN ............................................................ 129
Figure 6-10 The amplitude (A) and phase (°) of the XY flying dot ............................... 129
Figure 6-11 RUN 1 — RF signal ......................................................................................... 130
Figure 6-12 RUN 2 — RF + XY (default view) .................................................................. 130
Figure 6-13 RUN 3 — XY FLY DOT ................................................................................... 131
Figure 6-14 RUN 4 — XY + SCAN ..................................................................................... 131
Figure 6-15 RUN 5 — SCAN ............................................................................................... 132
Figure 6-16 The list of all parameters ................................................................................ 133
Figure 6-17 Materials — skin-to-core disbonds in tapered geometry .......................... 134
Figure 6-18 The Skin To Core Disbonds (Tapered) application ..................................... 135
Figure 6-19 The swept figure between two divisions ..................................................... 135
Figure 6-20 The full-screen display of the scan ................................................................ 136
Figure 6-21 The list of all parameters ................................................................................ 137
Figure 6-22 Materials — smaller disbonds using MIA technique ................................. 138
Figure 6-23 The Smaller Disbonds and Repair Identification application ................... 139
Figure 6-24 The scan signal of a disbond .......................................................................... 139
Figure 6-25 The signal angle adjusted upwards .............................................................. 140
Figure 6-26 The signal amplitude adjusted to enter the alarm box .............................. 140
Figure 6-27 The second scan over the disbond ................................................................ 141
Figure 6-28 The list of all parameters ................................................................................ 142
Figure 6-29 Materials — repaired areas (potting) using MIA technique ..................... 142
Figure 6-30 The Smaller Disbonds and Repair Identification application ................... 143
Figure 6-31 Adjusting the dot position .............................................................................. 144
Figure 6-32 The scan over the disbond and repaired area ............................................. 145
Figure 6-33 Adjusting the signal angle upwards ............................................................. 145
Figure 6-34 Adjusting the signal amplitude ..................................................................... 146
Figure 6-35 The second scan over the disbond and repaired area ................................ 146
Figure 6-36 The list of all parameters ................................................................................ 147
Figure 6-37 Materials — metal-to-metal bonds using resonance technique ................ 148
Figure 6-38 The Metal To Metal Disbonds application ................................................... 149
Figure 6-39 The CAL screen ................................................................................................ 149
Figure 6-40 The first dot recorded ...................................................................................... 150
Figure 6-41 The second dot recorded ................................................................................ 151
Figure 6-42 The GAIN adjusted to set the higher dot ..................................................... 151
Figure 6-43 The second scan over the disbonds ............................................................... 152
Figure 6-44 The list of all parameters ................................................................................ 153
Figure 6-45 Materials — delamination in composites using resonance technique ..... 154
Figure 6-46 The Delamination and Laminates Inspection application ......................... 155
Figure 6-47 The CAL screen ................................................................................................ 155