Olympus BondMaster 600 - 5 Control Functions; Powerlink; Figure 5-1 Powerlink Recognition Screen

DMTA-10045-01EN, Rev. E, August 2016
Control Functions 69
5. Control Functions
This chapter provides explanations of the control functions on the BondMaster 600
composite bond tester.
5.1 PowerLink
The PowerLink feature enables the BondMaster 600 to automatically recognize
Olympus PowerLink BondMaster probes when they are connected to the instrument.
The BondMaster 600 is then configured according to the parameters programmed
into the PowerLink ID chip. Each PowerLink probe is programmed at the factory to
provide its model number, preselected operating frequency, gain, and serial number.
When a PowerLink probe is connected, the BondMaster 600 displays the PowerLink
recognition screen (see Figure 5-1 on page 69).
Figure 5‑1 PowerLink recognition screen