Olympus BondMaster 600 - PC RF Mode - ALARM Menu in RF RUN

DMTA-10045-01EN, Rev. E, August 2016
Control Functions 83
5.3.4 RESON Mode — MAIN Menu
The RESON (resonance) mode uses a probe that is tuned to have a resonance at a
particular frequency. When resonance mode is selected, a frequency sweep is done to
determine the resonance frequency of the probe. The amplitude and phase of the
sweep are displayed (see Figure 5-7 on page 83).
Figure 5‑7 The resonance display
The following parameters can be adjusted on the RESON (resonance) MAIN menu:
• FREQ (frequency)
• GAIN (combined)
• H GAIN (horizontal gain)
• V GAIN (vertical gain)
• ANGLE
• PRB DRV (probe drive)
• LP FILTER (low pass filter)